Job Stories

Melissa, a homeowner in Temecula, CA, noticed signs of water intrusion in her home and became concerned about potential damage. Wanting to address the issue before it worsened, she reached out to Saber Foundation Repair for a professional assessment.   Our design specialist conducted a thorough inspection of the home and identified areas where water was entering and pooling. To effectively manage and prevent further water intrusion, the specialist proposed installing a WaterGuard system along with a SmartSump. This combination would ensure proper drainage and keep the home dry and protected.   Melissa agreed to the proposed solution, and our team installed the WaterGuard system and SmartSump. The installation was completed efficiently, providing Melissa with peace of mind knowing her home is now safeguarded against future water damage

Banning resident Pelton T. contacted Saber wanting to Seismic Retrofit his home in 1952.  Our Crew installed Universal Foundation Plates and A35 Framing Angles to strengthen the home's connection to it's foundation. These two products are approved by the California Building Code. Pelto now has peace of mind that his home won't slide off of it's foundation during a earthquake.

Helendale property owners Christine and Rosemary contacted Saber regarding a commercial property that they own. The walls had exterior and interior cracks and the doors and windows were sticking in the units. There were also cracks in the garage floor. our project design specialist did a full evaluation of this building. Our crews removed and replaced the concrete in the parking area. We added rebar to the push pier system that was installed. Last of all, we used our state-of-the-art PolyLevel process to level the uneven parts of the foundation. Christine and Rosemary were satisfied with the changes and the clean up.  

Saber was contracted to repair a foundation in Fallbrook, California.  The home had many cracks throughout in the slab and also in the walls and ceiling of the property.  The Saber crew used two push piers at specified locations to help stabilize the home and prevent it from any future settlement.  Once the piers were installed and the lift and stabilization of the home was complete the crew went to work repairing the large cracks that had formed around the property,  Using an epoxy injection the crew closed up the cracks.  Once the cracks had been sealed the homeowner can now lay new flooring and repaint the walls and ceilings as needed, instead of just covering up the issue the homeowner is happy to know that the foundation issue is resolved and the home is now stabilized from future settlement. 

Fallbrook resident Kathleen G. contacted Saber regarding cracks in the back patio of her home. The cracks were expanding and getting larger. Please see the attached picture. Saber's Project Design Specialist performed a extensive inspection of Kathleens home. Voids were found under some of the Patio Slabs. These were caused by settling, and shifting soils. Our crew drilled holes through the concrete, and into the Voids. We then filled the Voids with Polyurethane, by using our State-of-the-Art PolyLevel Injection Process. This lifted the slabs that had sunk, and eliminated all of the trip hazards.

Saber Geotechnical Construction Solutions proposed to stabilize an apartment complex in Agoura Hills using the Helical Piers and PolyLEVEL™ system.  PolyLEVEL™ is a two-part urethane that when combined, expands into a rigid foam used to fill voids, stabilize slabs and lift concrete.  Once injected through small 5/8 inch drilled holes in the surface or slabs, a chemical reaction converts the liquid urethane components into a strong, rapidly setting, waterproof foam material. In it’s foam state, PolyLEVEL™ is light weight, weighing two to six pounds per cubic-foot (pcf).  Opposed to mud-jacking which can weigh upwards of 120 pcf, thus adding a significant burden to the supporting soils under the slab, and potentially contributing to further settlement issues.  With a compressive strength of 10,800 pounds per square foot, PolyLEVEL™ has the strength to support the most demanding residential loads.  For this job, Saber will use the polyurethane injection as a void fill once the helical pier system has been installed and the structure has been lifted in order to prevent any future settling. 

Simi Valley resident contacted Saber regarding uneven concrete on his home's sidewalks. This was becoming a trip hazard.  Our project design specialist performed a complete evaluation. We were able to correct this trip hazard using our state-of-the-art PolyLevel process. Arvon was satisfied with the finished job and clean up.

Idyllwild resident Sean E. contacted Saber in regards to cracks in his home's foundation and deck. Our Project Design Specialist performed a complete evaluation of Sean's home. Our crew used Saber's PolyLevel Injection Process to level and strengthen the foundation of Sean's home and deck. The attached picture shows the deck area after it has been leveled, and the cracks have been caulked. Sean was happy with the result of Saber's work and clean up.

Sarah F. needed Saber's help regarding one of the cabins at a campground facility in Idyllwild. Project Design Specialist Paul D. was happy to do a thorough evaluation in such beautiful mountain surroundings. Due to the terrain, settlement issues are common in our local mountains. Paul recommended the installation of helical piers as well as Polylevel to repair the settlement damage as well as provide stabilization for years to come. Sarah gave Paul high marks on her survey. She writes, "Paul D. was very impressive. He walked me through what he was doing. He was easy to understand and very thorough. I was very pleased with the entire process. Thank you!" You are very welcome, Sarah!     

Lake Hughes resident Mary S. contacted Saber regarding her homes tilting brick fireplace creating cracks in the walls. Our Project Design Specialist performed a complete evaluation of Mary's home. Our crew filled a void beneath the fireplace using our Polylevel Injection Process. Saber then installed Push Piers to level the foundation of the home. The dirt excavation and the Push Pier installation are pictured. Mary was pleased with the completed job and the clean up.